Rx700NR MK is a Normal Range, for MultiKopters is designed with the benefits of easy integration for Multicopters, the brilliant choice for people that don't want to take the risk of having control and video/telemetry frequencies close to each other.
Uptimized input filter so it can co-exist with strong 2.4Ghz on board video transmitters.
Wire antenna mounted directly on the rx.
The PPM pin is normally ppm out when < 12ch are used, but IF 12ch are used it switches into ch12 servo signal,
If you want to use a 12ch ppm signal, ask for 12ch ppm version (just a firmware change/upgrade)
PPM out is the same as sum-signal and this is offcourse fully compatible with mikrocopter controller board, all RX have this.
Servo pins how to connect explained see this so you connect it all right.
Servo signal pulse output: 3.3V positive
4 servo channels (ch5 ch6 ch7 ch8)
PPM output (also called SUM signal)
Rssi output 0.5 to 3.3V from min to mix
Supply voltage 4-10 Volts
The receiver board is 50 x 50mm and fits perfectly om the Mikro Kopter controller board.
Weight 10 Grams
Supply current RX alone 18mA at 5V
Wide user temperature range -40C to +70C ambient
User firmware upgradeable
Possible to upgrade to MCX connector
Wideband frequency hopping system
Uses 433 to 440 MHz ISM licence free band